• 목록
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

The government of the United States built its first international border fence from 1909 to 1911 along the California-Mexico border. In 1924, the United States created its border patrol, which built extra barbed wire fences on the Mexican border; this time to forestall people from crossing. This decision was affirmed by the US Supreme Court in 1892. In 1898 Gates took control of Washburn and Moen, and created the American Steel and Wire monopoly, which became a part of the United States Steel Corporation. Gates subsequently had a falling out with Washburn and Moen and Isaac Ellwood. As with any fence, barbed wire fences require gates to permit the passage of individuals, vehicles and farm implements. Gates range in width from 3.5 metres (12 ft) to permit the passage of autos and tractors, to 12 metres (40 ft) on farm land to go combines and swathers. In New Zealand wire fences must provide passage for canines since they're the principle technique of controlling and driving animals on farms. The Fence Cutting Wars ended with the passage of a Texas law in 1884 that made fence reducing a felony.

This led to disputes recognized because the range wars between open vary ranchers and farmers within the late 19th century. The ranchers in place, particularly in the Texas Panhandle, knew that their holdings couldn't help the grazing of additional cattle, so the only alternative was to dam the migrations with barb wire fencing. Barbed wire emerged as a significant source of conflict with the so-referred to as "Big Die Up" incident in the 1880s. This occurred because of the instinctual migrations of cattle away from the blizzard situations of the Northern Plains to the warmer and plentiful Southern Plains, soft flat wire electric but by the early 1880s this space was already divided and claimed by ranchers. Barbed wire supplied a cheap method to control the movement of cattle. This technique must be averted because whereas sleeves can work effectively on repairs in the course of the fence where there shouldn't be sufficient wire for hand knotting, they tend to slip when beneath tension.

This is the most common method of attaching wire to a corner publish. This has the perform of a corner put up and brace assembly but handles tension from opposite sides. A very powerful and most time-consuming part of a barbed wire fence is constructing the nook publish and the bracing meeting. Wire vise. The wire is passed via a hole drilled into the corner submit and is anchored on the far aspect. Barbed wire is normally placed on the internal (pasture) aspect of the posts. Fabricated from wire with posts attached at each ends and in the center, it is completely wired on one side and attaches to a gate publish with wire loops on the other. On the other end a full-size publish, the tractor post, is placed with the pointed finish upwards with a ring on the underside stapled to the other corner publish, the latch submit, and on prime a ring is stapled to the tractor put up, tied with a Stockgrower's Lash or one of numerous other opening bindings.

Wires are then tied across the post at one end then run to the other finish where they are stretched by hand or with a stretcher, before posts are stapled on every 1.2 metres (4 ft). Both sorts are galvanized for longevity. Galvanized wire is classified into three classes; Classes I, II, and III. 1⁄2-gauge, zinc-coated (galvanized) steel and is available in rolls of four hundred m (1,320 ft) size. Corner posts are 15 to 20 centimetres (6 to eight in) in diameter or bigger, and a minimal 2.5 metres (eight ft) in length might include handled wood or from durable on-site timber equivalent to osage orange, black locust, purple cedar, or pink mulberry, additionally railroad ties, phone, and power poles are salvaged for use as nook posts (poles and railroad ties have been typically treated with chemicals decided to be an environmental hazard and can't be reused in some jurisdictions). Bracing wire is usually smooth 9-gauge. Line posts are set to a depth of about 76 centimetres (30 in). Posts are 10 centimetres (4 in) in diameter driven at the least 1.2 metres (4 ft) and could also be anchored in a concrete base fifty one centimetres (20 in) sq. and one hundred ten centimetres (forty two in) deep.